Printing Auxiliary Material,High Tension Printing Auxiliary Material,Custom Squeegee Rubber,A3 Printing Ink shaoxing gesheng wire mesh co., ltd , https://www.gscreenmesh.com
Waste Renovation: Sprite Bottle Vase
First prepare a drinking Sprite bottle, a pair of scissors
The Sprite bottle is cut into this way.
This section is kept first
The following paragraph is evenly cut into eight at the kerf, not too precise, but not too far. Don't cut too deep, just an inch or so. After cutting it is like this
Cut each one out and cut out a small piece like a shovel. Be careful not to cut it.
Small pieces cut into leaf shapes
Press the blade
Finished effect
Follow this method to make a second piece
Not much to say, cut eight pieces
Remember not to cut the following ones, it is also useful.
Also cut into leaves at a lower position, so there are two layers of leaves
Slightly treat the remaining small pieces, which are cut into lanceolate strips.
It’s almost done after cutting, all the time is on the scissors.
Insert the finished product into the upper part of the Sprite bottle that has just been cut. If you want to arrange flowers in it, you can find a way to insert the above half.
Waste Renovation: Sprite Bottle Vase